Mature Metal Sizing Rings Too Small

[sublimation]

Help!

Has anyone else had this problem? My guy and I ordered a set of sizing rings after we tried the CB-6000, which there was NO way he was going to fit.

Even the largest MM sizing ring #9 is too small. He can fit both balls, but not the shaft in...there is no way.

It seems unreal that he cannot fit, but we have tried a few times. Any advice or suggestions?

[Michele]

I have trouble understanding that his balls both fit but he can't squash a flaccid penis in after his balls are in? It's smooshy, you should be able to squash it under the ring... then you would know if it was too tight. Is he trying the rings on alone? He really needs to be alone and flaccid. Any attempt at an erection would obviously make it extremely difficult to get in a sizing ring. Also is he using any lube to get the ring on? Lotion? Something too help it slip past the roughness of the ring?

[sublimation]

Yes, he was alone and completely flaccid. He said even with just the balls in the ring he could not fit a finger in through the ring.

I haven't seen the attempt yet, but he says that there is absolutely no way, even with lube.

[Michele]

You might want to hit up the hardware store then to get a bigger ring to see what fits... MM can make whatever size you need. My paper is in the other room so I can't remember the size of #9 but maybe he needs a 2.75"ring but they sell them in the hardware store where here could get a couple and check it out. Or take a ribbon and wrap it around the back of the sack and up around the base of the cock. Then measure the circumference out on a ruler.

The ribbon or string might be a start

(Let me know if you need to know more about what I mean)

[sublimation]

I went to a hobby store and found some craft type rings. A 2 5/8 is a bit too big, so I ordered some cock rings in the various sizes to try out and see how they fit.

Thanks for the advice!

[ILoveMyChoice]

Hey!

This may be a bit late, but I recall reading somewhere that MM has larger sizing rings available over-and-above those listed on the site. They are just not advertised (don't ask me why-I'm not sure!!!)

I 'think' you can get them by asking MM directly via an e-mail....

With the absolute kindest regards.

J.