
trying to get use to my cb6000s
-
- Posts: 7
- Joined: Tue Apr 22, 2014 2:53 am
trying to get use to my cb6000s
Ok I got a cb6000s a couple months ago I been playing with it off and on trying to get use to it. I think I found the right ring and spacer. (the second largest ring and the smallest spacer) It is comfortable while wearing it sometimes if I touch my balls the testicals feel kind of cold mostly when I get hard. But stay warm while im relaxed. Also they never turned colors when they feel cold they even feel cold sometimes when im not locked up lol so it never felt like a issue. Now the big problem I went ahead and tried to wear it for a week straight and it was going good little to no pain then going into the 3rd day I had a tare able pain that felt like it was coming from inside my ball sack and my skin started changing colors so I took it off and the pain slowly went away after a couple hrs. I went to the next size ring with the smallest spacer and after awhile it started too feel the same pain. If I go up a spacer size my testicals start getting squashed between the ring and tube. So any advice is greatly appreciated!
Also I am thinking of getting a custom cage once I get the sizing figured out since the cb6000s is pretty small for me think I will still have the same issues? thanks again!

Re: trying to get use to my cb6000s
The problem I had was with the spacers the smallest ones provided using the second largest ring, #2 ring would allow the cage to flex between the ring and cage. I actually had my ball slip though the space, very painful. What happens is with everything flexing your ball gets pinched and this hurts a lot. I had to sand down the middle spacer to a point where the ring and cage almost touched then I picked up some thin spacers from Lowes and put between over the posts between the cage and ring. Now the lock pin is way to long so you have to drill a new hole for the lock I also added a spacer between the cage and lock so the lock isn't against the cage if you make it where you have force the shackle though the hole I puts pressure on the cage keeping it from flexing as much. I tried going flat against the ring but the cage would flex and skin got pinched, this hurts a whole lot, that why you need to leave about a 1/6 to an 1/8 of an inch of space, using spacers. Now I end up breaking rings where the pins go through I don't think this is from using this setup but I can't be sure. Your anatomy may not allow for this setup ,if it does it may solve your problem.
Hope this helps.
Wrangler
Hope this helps.
Wrangler
- Locked by LRC
- Posts: 1034
- Joined: Tue Jan 18, 2011 1:45 am
- Location: Midwest, USA
Re: trying to get use to my cb6000s
Soon after the pain went away you said you tried a different combination. How long was soon? Whenever I feel discomfort to the point of having to remove the device I wait at least a day before trying it again. If something was irritated it would need a rest period. If the pain was enough, no combination will feel right without a proper rest period.
You also state the 6000s is too small for you. If it's length, part of your problem may be the constant pulling of your sack away from the body. With a proper fitting device this will happen when erect and can be uncomfortable. If this was continuous for a couple of days it would become unbearable.
You also state the 6000s is too small for you. If it's length, part of your problem may be the constant pulling of your sack away from the body. With a proper fitting device this will happen when erect and can be uncomfortable. If this was continuous for a couple of days it would become unbearable.
Current device - MM Custom
Previous devices - CB2000, 3000, 6000, 6000s, Curve
Previous devices - CB2000, 3000, 6000, 6000s, Curve
-
- Posts: 7
- Joined: Tue Apr 22, 2014 2:53 am
Re: trying to get use to my cb6000s
Thanks for the advice guys!
I think my problem is that my balls hang pretty high so things get pretty tight. also I think I meant too say im to small for the cb6000s lol
But it hardly pulls against my balls when I start getting hard. But I will try some more combos also im a huge grower so once im relaxed with the largest rim sometimes the device basically slides down my penies and I can pull it out easy but my balls are still stuck in.


Re: trying to get use to my cb6000s
I try to keep my balls snug up against to the device so when the scrotum does retract it doesn't have to pull through at all. I also made a sleeve for the bottom ring and that has made for less friction against the plastic.
-
- Posts: 3893
- Joined: Thu Nov 10, 2011 5:49 pm
- Location: Northern New England
- Last orgasm: October 21st, 2020
- Orgasms this year: 4
- Gender:
Re: trying to get use to my cb6000s
You need a smaller ring. If you are practically falling out of it as you describe, then the ring you are using is far too big.Uselesssissy wrote:Thanks for the advice guys!I think my problem is that my balls hang pretty high so things get pretty tight. also I think I meant too say im to small for the cb6000s lol
But it hardly pulls against my balls when I start getting hard. But I will try some more combos also im a huge grower so once im relaxed with the largest rim sometimes the device basically slides down my penies and I can pull it out easy but my balls are still stuck in.
04/07/19 "And then I 'punished' you by making you lick my pussy after I let my other 'boy' fuck me." --Mrs. Twisted
- LockedUp24
- Posts: 333
- Joined: Fri Jan 24, 2014 12:52 pm
- Location: Ireland
Re: trying to get use to my cb6000s
Oh the joys of trying to find the right combination...Im kidding ITS A NIGHTMARE.
Ive had to resort to adding a Dental safe rubber all the way around the biggest ring just to stop the plastic burn.
Im a high tighty too with different sized balls so 1 ring is too tight another too small and i pop back out.
The rubber has stopped all the rubbing and will also stop "MOST" slips that smaller ball likes to do.
It still wont stop all slips and im permitted a Key sealed in an envelope for work hours and she does let me run free more these days ??
Ive wanted to get the new Holy trainer but my KH wont allow it right now unless she wishes for true serious chastity play.
Ive had to resort to adding a Dental safe rubber all the way around the biggest ring just to stop the plastic burn.
Im a high tighty too with different sized balls so 1 ring is too tight another too small and i pop back out.
The rubber has stopped all the rubbing and will also stop "MOST" slips that smaller ball likes to do.
It still wont stop all slips and im permitted a Key sealed in an envelope for work hours and she does let me run free more these days ??
Ive wanted to get the new Holy trainer but my KH wont allow it right now unless she wishes for true serious chastity play.
Her Words Her Commands....End of Line.
Re: trying to get use to my cb6000s
i have found that popping out is not so much a function of ring size as it is the gap between the ring and the cage (on the CBxxxx). So if you need a smaller ring you may need a bigger spacer, in my case i was OK with a bigger ring and no spacer or a smaller ring with a small spacer, both gave about 8 or 9 mm between cage and ring but in a totally different configuration. Experiment a bit with it off and you'll see what i mean.
d
d
New Zealand
Still having difficulty getting back into 24/7/365 chastity since covid. Very tender old man skin under the scrotum damages easily. Trying an HT Mk5 nub now. Love the fact you can’t pull out of it, hope my skin toughens up.
Still having difficulty getting back into 24/7/365 chastity since covid. Very tender old man skin under the scrotum damages easily. Trying an HT Mk5 nub now. Love the fact you can’t pull out of it, hope my skin toughens up.
-
- Posts: 7
- Joined: Tue Apr 22, 2014 2:53 am
Re: trying to get use to my cb6000s
Hello and thanks for all the great tips everyone! I been doing some experimenting with the different size rings and spacers and found what I think is the best fitting size for me is still the second largest ring with the smaller spacer. Now what I am still a little concerned about Is my balls feel kind of cold at times while wearing the device but there not really getting discolored. Im not sure if its because im loosing circulation or if its because they cant get close enough to my body to warm up. But I just wearing the device for most of the day and trying to train my body to get use to it more. My biggest issue is one moment my sac is tight against my body and I am a little larger then a couple hrs later it drops and I shrink a little causing the device to start falling off so im just going too keep wearing it till maybe I can fit a smaller ring. Thanks again everyone!
-
- Posts: 59
- Joined: Tue Apr 08, 2014 10:15 am
- Location: Pennsylvania
Re: trying to get use to my cb6000s
tell me about it, scared to get a custom device for this exact reason (measure 20 times submit sizes once) lolLockedUp24 wrote:Oh the joys of trying to find the right combination...Im kidding ITS A NIGHTMARE.
Wearing: Reglued Cb6000
Locked to KH Miss Elizabeth
Locked to KH Miss Elizabeth