How do you keep a chastity device on?

[northernleo]

Hello everyone, this is my first post and I apoligise if this topic has been done to death before but I am curious as to how others cope with the various chastity devices around.

I've tried CB 2000,3000,Curve and the CB6000 in the hard plastic types and I have also tried the birdlocked and bon4 silicone devices. The problem with all of the devices that I have tried is that each testicle thinks it is in a race to escape and quite often one or the other tends to push its way back through the ring and up into my body.

I'm looking at the dickcage but wonder if that will have the same effect.

How does anyone stop this or is it just me and no one has a problem. I know its particulary bad during the winter months when both testes shrink and it has not been unknown for me to be wearing a device one minute and then I can feel it gradually becoming slacker until it falls off.

I think that the answer may be a steel device but this is a non starter due to security devices at airports.

Any ideas ?

[TwistedMister]

You need to adjust your base ring size and/or your gap size. One or both of these is too big, which allows your testicles to pop through.

Start with the base ring- use the smallest size that will get you through the night without being constantly awakened by painful nocturnal erections. (If you don't wear it while sleeping, you can probably go even smaller since wakeful erections are subject to your control.)

Once you have found the correct size for the base ring, reduce the gap by using smaller spacers between the cage and the base ring. To keep a tight fit, use a spacer between the cage and the lock if necessary. The plastic pins of the CBxxxx line have a bit of flex to them, so you may need to decrease the gap more than you might think you need to.

[Atone]

The plastic pins of the CBxxxx line have a bit of flex to them, so you may need to decrease the gap more than you might think you need to.

also, make sure the locking post on the CBxxxx is tight. There should be a really thin washer that you might need to use after the tube but before the lock. In my experience with the CB3000 I needed that. You should have to really hold it together tight in order to get the lock on, if not you probably need the thin washer. If it is loose the pins will flex too much and you will almost certainly have this problem.

[Locked by LRC]

Keeping with what Atone said; when I was using the CB's I had the spacers set so the lock barely went in. I found the spacer combination that the lock would almost go in and sanded the spacer until the lock would be tight going in.
My reason to start this was for a different reason. I have an active job and occasionally I would get a small piece of penis skin between the spacers when bent over or twisted. When I stood up I knew when the skin was pinched.

[Finn]

I have had basically the same issue. I can get a fit where the testicle doesn't escape, but I tend to get irritation more frequently if I wear it that tight. I'm too big around for a smaller base ring and reducing the gap helps/works but at a price.