New Steelworxx - sliding down

For the gearheads in the audience
TulsaChaste
Posts: 2
Joined: Sat Mar 03, 2012 9:48 pm

New Steelworxx - sliding down

Post by TulsaChaste »

I just received a new Steelworxx revenge but it slides down my shaft about 1.5 cm when walking around. The A-ring is 45mm, 35mm tube and it's 100mm long. The A-ring does not seem too big or too small, but I'm thinking maybe I should go with a smaller one. Does anyone have any advice here?

Other then that, I am extremely pleased with the device - high quality craftsmanship much more comfy then the CB6000.
Locked4Xtine
Posts: 69
Joined: Tue Nov 22, 2011 8:28 pm

Re: New Steelworxx - sliding down

Post by Locked4Xtine »

i had a similar problem and it could be a number of things...

it could be that the ring is a bit too loose - be careful if its not the ring tho cos a tighter ring could be too tight

it could be that the gap between the tube and the ring is too big - esp. true if you have saggy balls

it could be the tube is too wide to grip onto your cock if the device doesn't already get a good grip around your sack


what plastic ring were you wearing?
you normally need to go a few mm tighter for steel

what spacer did you use on the CB and what gap do you have on the Steelworxx?

you have a long tube, so your diameter is probably right if your cock is that long, but if your nuts a v saggy then the device needs to grip your cock as much as your nuts

such a long device will weigh quite a bit too

1.5cm isnt so bad when your cock is 10cm long tho