Hello. Just bought a smaller knockoff. It's much easier to get into and the pinch points seem to be easy to cover up. Overall it seems very comfortable and easy to conceal under regular clothing. Was really happy with it until I get an erection. My others have felt awkward and and times painful or even good. But this one feels like it is going into my body and ripping off my balls. Is this normal? Maybe I'm just spoiled with my older longer one that prevented masterbation but allowed most of an erection. It's very uncomfortable when I'm hard and last night it woke me up and wouldn't go down. Got a little scared and took it off. Had a raging hardon for two hours after and it felt amazing. Still I'm afraid I might cause some damage going this small compared to my others.
The base ring is 45mm I think as opposed to my 50mm ring I had. And the overall length is probably 2.5 and not The oversiZed 4" I had before. Any thoughts? Is it supposed to be that uncomfortable when hard even though it's pretty snug but comfortable when soft?
New cage may be too small/tight
Re: New cage may be too small/tight
The closer you are to flaccid size the better nocturnal erections will be, though they will not be completely pain free for a while until your body adjusts. I think maybe the 45mm ring maybe too small. Can you fit one finger inside the ring when wearing it?
-
Grizzly228
- Posts: 204
- Joined: Fri Apr 18, 2014 11:06 am
Re: New cage may be too small/tight
I doubt I could fit anything between it. When flaccid it's comfortable but snug. But I used to like the feeling when erect. But in this cage erections would be unwanted for sure
Re: New cage may be too small/tight
my experience is if the base ring is too tight it will work like a cockring and keep blood trapped for longer periods of time. Blood trapped for long periods can be a bad thing especially if its turning blue or purple. Here is my take on the perfect fit for a ball trap cage device. Cage should be as short in length and diameter of your normally flacid size, some people subtract 1/2" from length. Gap should be enough that your balls dont pop through and the base ring should be snug while flacid with the ability to put one finger under the ring. I'm no expert but that is what I have gathered over the years.
-
Grizzly228
- Posts: 204
- Joined: Fri Apr 18, 2014 11:06 am
Re: New cage may be too small/tight
I think that's what's happening. Haven't noticed any color changing or cold areas which I've heard to watch out for. But when I get full size and more than half chub it takes a long time to come back down. When it hits that point i generally take it off to be safe. It's a shame cuz other than that it's very easy to wear and conceal.
Maybe I just need to go up a few mms
Maybe I just need to go up a few mms
Re: New cage may be too small/tight
You are probably on the money. We've tried a number of different CB devices. The issue is that my balls are so small, even with the CB6000s, the smallest ring, and the smallest pin, they slip out.Grizzly228 wrote:I think that's what's happening. Haven't noticed any color changing or cold areas which I've heard to watch out for. But when I get full size and more than half chub it takes a long time to come back down. When it hits that point i generally take it off to be safe. It's a shame cuz other than that it's very easy to wear and conceal.
Maybe I just need to go up a few mms
A Holy Trainer should arrive tomorrow. Based on everything I read, it's a matter of spending money on devices until you find what works for you.