Update to ring designs.
I've made a few rings now, because I have low balls. And I mean hangers.
If I pull my balls away from my body there is 4" of scrotum before my balls and this causes a big problem.
Basically the correct size cage (according to the books) slides down this spare sack and becomes a pendulum. Worse still the tube is now the wrong size and I had to use a shoelace to keep it in place and stop ball pain at night.
I compensated by getting a shorter cage, but this meant the top of my dick was behind the ring. Easy to pull out if I wanted to and that bothered me.
https://www.dropbox.com/s/s02qrqgv8ewkc ... 7.jpg?dl=0
But it has been fine to wear for two years, I just don't like that it looks so escapable.
So I made some rings myself and the "whopper" is the best by far. It fits so shug against my body while also resting on my balls so can't pull away as you can see.
https://www.dropbox.com/s/uigv1yfqklqjk ... 5.jpg?dl=0
The ribs within the ring grip like hell, no slide at all even if my balls weren't there in the way.
In order to fit it or remove it I have to push my penis inside my body and line it up. It then finds its own way in like a slugs head. No way this can be done with cage in place.
These are the designs. All of them are good to wear, don't slip. Very light.
It's a work in progress and I'm still working on it and also other styles of rings and cages.
Basically it makes an off the shelf cage customizable, it's also fun and I got a free 3D printer put of it
Hope it's OK to post these. Please remove if not. I have more to show designs in better view etc.
https://www.dropbox.com/s/qahe4zdmvaoaw ... s.jpg?dl=0
https://www.dropbox.com/s/520yv093n2jt4 ... 8.jpg?dl=0
The pic below shows the cage length reduction needed if the ring is much wider.
https://www.dropbox.com/s/abi9ii8agn3ua ... 4.jpg?dl=0
For the gearheads in the audience
1 post • Page 1 of 1