Ring Sizing

For the gearheads in the audience
Posts: 72
Joined: Sat Feb 09, 2019 6:47 am

Re: Ring Sizing

Post by Devoted2Her » Tue May 21, 2019 5:17 am

@ChastityNoob ... I get it, and believe me the temptation is there for me as my device is not escape proof, I think about masturbation all the time, the cage is a reminder and a hindrance, not 100% foolproof but the mental reminder is just as strong as the physical barrier for me. At least at this point.
0 x

Posts: 4
Joined: Tue Jun 04, 2019 2:53 am

Re: Ring Sizing

Post by ukdave » Wed Jul 10, 2019 1:12 am

Sorry to resurrect an old post, but to offer a couple of things here. First you can change the shape and angle of the HT ring by soaking it in hot water, bending it and then plunging it into cold. I didn't realise this at first, but managed to get it much more comfortable.
For me ring size was the most difficult thing to get right - and I had loads of devices on the journey. The problem for those of us who need a large ring size and a small tube is that the gap between the bottom of the tube and the bottom of the ring is often big enough to let a testicle through - especially in the cold. This is different from the gap that the custom manufacturers talk about - and there is not much you can do to change it. I needed to train myself to use a slightly smaller ring - I now have a Jailbird and a small genuine HT - had some discomfort with the ring in both to start with but fine now.
0 x

User avatar
Posts: 671
Joined: Tue Dec 07, 2010 9:41 am
Location: USA

Re: Ring Sizing

Post by danj » Wed Jul 10, 2019 9:06 am

I found the gap size to be critical. I went from a 15mm gap on my first custom device (Steelworxx Steelheart) down to 10mm on my Looker 3. I went from having an occasional escaped ball to never having a problem.
1 x

and yes, that IS my beautiful hotwife wearing the key to my cb-6000s!

Currently Own: CB-6000s, Steelworxx Steelheart (2), modified Steelworxx Looker 3, and DH Gate A271
Currently Wearing: Steelheart


Post Reply