Help with sizing rings...
Help with sizing rings...
I recently bought the plastic sizing rings from MM, but I'm having trouble getting them on. I used a little bit of lube and used the biggest ring, but I'm having problems getting both of my balls through the ring and getting them to stay in the ring once they are through. They seem to keep wanting to jump back out of the ring. Any suggestions?
0 x
Re: Help with sizing rings...
You have to pull the scrotum skin through first and then effectively “cuff” them by putting your finger and thumb behind them while you push your shaft through. Once they’re all in they shouldn’t go back easily.
MsM’s ld
MsM’s ld
0 x
New Zealand
After a year post covid of “freedom” I am trialing a good old HT V3 nub modified by me to have a glans ring so no pullout. Working well so far.
After a year post covid of “freedom” I am trialing a good old HT V3 nub modified by me to have a glans ring so no pullout. Working well so far.
Re: Help with sizing rings...
And if they still pop back, then you are probably using too large a ring.
0 x
Re: Help with sizing rings...
Thanks. I am having problems with them popping back out after it is on. Maybe I'll give a smaller ring a try.
0 x
- Bird in a Cage
- Posts: 243
- Joined: Fri Feb 05, 2016 4:38 pm
- Location: A Gaijin in Japan
Re: Help with sizing rings...
Try doing it in a hot shower, when your scrotum is relaxed. If you’re high and tight, trying a sizing ring will be tough.
0 x
...
Securely within an MCN Adaptus.
Securely within an MCN Adaptus.
Re: Help with sizing rings...
Thanks, Bird in a Cage! I think I read that suggestion somewhere else and I gave it a try. Turns out it worked. Each time I've put the ring on, it's gotten easier and easier.
0 x